Enabling Pss1/Q.sig - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide

Enabling PSS1/Q.SIG

This procedure configures an ISDN port for use with Q.SIG / PSS1 protocol.
Mode: port bri <slot> <port> or port e1 <slot> <port> or port t1 <slot> <port>
Step
1
[ name ] (prt-bri)[slot/port]# q921
2
[ name ] (q921)[slot/port]# q931
3
[ name ] (q931)[slot/port]# protocol pss1
Procedure: To configure ISDN layer 3 (Q931) settings
Mode: q931
Step
1
node (q931)[slot/port]#protocol dss1
or
node (q931)[slot/port]#protocol pss1
or
node (q931)[slot/port]#protocol ni2
2
node (q931)[slot/port]#signalling-rule
etsi
or
node (q931)[slot/port]#signalling-rule
pss1old
or
node (q931)[slot/port]#no signalling-rule
3
node (q931)[slot/port]#uni-side net
or
node (q931)[slot/port]#uni-side user
ISDN port configuration task list
Command
Command
35 • ISDN port configuration
Purpose
Enter Q.921 configuration mode
Enter Q.931 configuration mode
Define PSS1 / Q.SIG as layer 3 protocol
(Default: DSS1)
Purpose
Specify the ISDN layer 3 protocol (Default:
BRI: dss1, E1: dss1, T1: ni2)
The ISDN layer 3 is the network signaling
protocol. SmartWare ISDN ports support
Euro-ISDN (E-DSS1), Q.SIG (PSS1) and
National ISDN (NI2) signaling.
The layer 3 signaling must correspond to the
connected ISDN equipment or network.
Specify channel numbering (Default: etsi)
Some older Q-SIG variants make use of a
channel numbering scheme that differs from
the standard ETSI method. In most cases the
ETSI numbering applies. Unless the connected
ISDN devices and configured protocols
require a different scheme, make sure the
numbering is set to ETSI.
Specify the UNI side of the interface.
If not defined on layer2 (q921 mode) this set-
ting also specifies the UNI side setting for
layer2.
The layer 2 settings also apply to Q.SIG
(PSS1) interfaces.
Make sure that the device connected to a
SmartNode ISDN port is operating the oppo-
site side of the configured uni-side.
464