Creating An Administrator Account; Displaying The Cli Version; Displaying Account Information - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
node(cfg)#copy running-config startup-config

Creating an administrator account

Administrators can run the
uration modes. Therefore administrators can modify the system configuration, as well as view all relevant sys-
tem information.
Creating a new administrator account is described in the following procedure:
Mode: Operator execution
Step
1 node >enable
2 node# configure
node(cfg)# administrator name password password Creates a new administrator account
3
node(cfg)# copy running-config startup-config
4
Example: Create an administrator account
The following example shows how to add a new administrator account with a login name super and a matching
password Gh3*Ke4h.
node>enable
node#configure
node(cfg)#administrator super password Gh3*Ke4h
node(cfg)#copy running-config startup-config

Displaying the CLI version

This procedure displays the version of the currently running CLI.
Mode: Operator execution
Step Command
1 node> show version cli
Example: Displaying the CLI version
The following example shows how to display the version of the current running CLI on your device, if you
start from the operator execution mode.
node>show version cli
CLI version : 3.00

Displaying account information

You can use the command to display information about existing administrator and operator accounts.
show
This command is not available for an operator account.
The following procedure describes how to display account information:
Accessing the SmartWare CLI task list
command and access additional information within the SmartWare config-
enable
Command
Displays the CLI version
4 • Accessing the CLI
Purpose
Enters administration execution mode
Enters configuration mode
name and password password
Permanently stores the new administrator
account parameters.
Purpose
54