Ending A Telnet Or Console Port Session; Showing Command Default Values - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide

Ending a Telnet or console port session

Use the command in the operator or administration execution mode to end a Telnet or console port ses-
logout
sion. To confirm the
logout
Mode: Operator execution
Step Command
1 node> logout
Example: End a Telnet or console port session
The following example shows how to terminate a session from the administrator execution configuration
mode.
node>logout
Press 'yes' to logout, 'no' to cancel :
After confirming the dialog with "yes", the Telnet session is terminated.
Note
Using the command
Telnet or console port session, but without any confirmation dialog.

Showing command default values

If a command is set to its default value, it is not displayed in the running-config in order to make it more read-
able. There are a few exceptions to this rule. The command cli config defaults makes commands also appearin
the running-config that are set to default values. no li config defaults turns it off.
Accessing the SmartWare CLI task list
command, you must enter yes on the dialog line as shown in the example below.
Terminates the session after a confirmation by the user.
exit in the operator execution mode also terminates a
Purpose
4 • Accessing the CLI
58