Deleting Call Services - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Context CS
Step Command
[ name ] (ctx-cs)[switch]#[no] ser-
1
vice bridge BRIDGE1
[ name ] (svc-bridg)[BRIDGE1]#port
2
DIALER
[ name ] (port)[DIALER]# dial persis-
3
tent 123 dest-interface REMOTE
[ name ] (svc-bridg)[BRIDGE1]#port
4
LISTENER
[ name ] (port)[DIALER]# no dial
5
Configuration Example:
context cs switch
routing-table called-e164 DISPATCH
route 1 dest-service BRIDGE1.dialer
...
service bridge BRIDGE1
port listener
mode listening
no shutdown
port dialer
mode dial-persistent 1 dest-interface REMOTE
no shutdown
interface h323 REMOTE
bind gateway h323
route call dest-table DISPATCH
remote 172.16.32.37
interface fxs PHONE1
route call dest-service BRIDGE1.listener

Deleting call services

To remove individual call services you can use the
Procedure: To delete a call service
Call router configuration task list
Enters the bridge service configuration mode / deletes a
bridge service.
Creates a port on the service that can accept or spawn calls
(the max number of ports is currently limited to two)
Configures the port to actively dial the called-party "123" to
the destination REMOTE. This connection is kept open until
the service is shut down, or a "no dial" command is issued. If
the remote side terminates the connection, the port tries to
reconnect. As soon as the connection is established, the call
is connected to all other calls present on the service.
Creates a port on the service that can accept or spawn calls
(the max number of ports is currently limited to two)
Without entering a "dial" command, or by specifying "no
dial", this port does not dial, but listen for incoming calls. If a
call comes in, it is automatically connected to all other calls
present on the service.
form of the
no service
33 • Call router configuration
Purpose
command.
438