Patton electronics SmartWare R.3.20 Software Configuration Manual page 271

SmartWare Software Configuration Guide
Mode: Configure
Step
node (cfg) #port ethernet slot port
1
2 node (prt-eth)[slot/port]# encapsulation
{ip|pppoe|multi}
3 node (prt-eth)[slot/port]# [no] bind inter-
face name [router ]
node (prt-eth)[slot/port]#[no] shutdown
4
5 node (prt-eth)[slot/port]#pppoe
node (pppoe)[slot/port]#session name
6
7 node (pppoe)[slot/port]# [no] bind inter-
face name [router]
or
node (pppoe)[slot/port]# [no] bind sub-
scriber name
8 node (pppoe)[slot/port]# [no] use profile
(optional) ppp name
node (session)[name]#service Service-
9
(optional) Name
10 node (session)[name]#access-concentra-
(optional) tor AC-Name
11 node (session)[name]#[no] shutdown
PPP configuration task list
Command
24 • PPP configuration
Purpose
Enters Ethernet port configuration mode for the
interface on slot and port
Defines the payload type(s) to be used on the
Ethernet:
'ip': IP traffic only (not used for PPP)
•
'pppoe': PPPoE sessions only
•
'multi': both IP traffic and PPPoE sessions
•
Binds the Ethernet port to the IP interface to be
used for the direct IP traffic (only required if
encapsulation 'ip' or 'multi' is selected)
Enables the ethernet port
Enters PPPoE mode
Creates PPPoE session with the name name
Binds the PPPoE session directly to the IP inter-
face name in case no authentication is required
Binds the PPPoE session to the PPP subscriber
name in case authentication is required
Assigns a PPP profile other than the default pro-
file to this PPPoE session
Defines the tag 'Service-Name' to be supplied
with Active Discovery in order to identify the
desired remote peer (check whether the remote
peer supports this feature)
The Active Discovery only accepts the PPPoE ses-
sion if the remote peer provides tag 'AC-Name'
with its Active Discovery Offer as specified. This
allows to identify the desired remote peer
Initiates the establishment of the PPPoE session
and the PPP connection
271