Changing The Default Udp Port Range For Rtp And Rtcp - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
The necessary routing-table entries for the scenario described are listed below.
node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]# route 10.1.5.10 255.255.255.255 172.16.40.2
node(ctx-ip)[router]# route 10.2.0.0 255.255.0.0 172.17.100.2
node>show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
Destination
---------------------------------------------------------------------
* 127.0.0.1/32
* 172.16.40.1/24
* 172.17.100.1/24
* 172.17.100.0/24
* 172.16.40.0/16
* 10.1.5.10/32
* 10.2.0.0/16

Changing the default UDP port range for RTP and RTCP

The UDP port range to be used for RTP streams can be configured using the following procedure:
Mode: context ip
Step
[ name ] (ctx-ip)[router]# rtp-port-range <start-port> <end-port>
1

Changing the default UDP port range for RTP and RTCP

Nexthop Protocol
local
local
local
wan local
lan local
172.16.40.2 static
172.17.100.2 static
Command
16 • Basic IP routing configuration
Metric Flags Used
0 LHG
0 LHG
0 LHG
1 UL
1 UL
0 U
0 U
Define the UDP port range
for RTP/RTCP streams.
n/a
n/a
n/a
0
0
0
0
Purpose
195