Making A Second Call While Holding First Call - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Note
This feature is not used when the connected analog equipment is a fax,
answering machine or similar device.
Procedure: To reject a waiting call, when a waiting call is announced with a special tone signal, the user
can either:
• Press flash-hook, followed by the 0 key
• Ignore the call waiting signal
The waiting call will be rejected.
Procedure: To accept a waiting call, when a waiting call is announced with a special tone signal, the user can:
• Press flash-hook, followed by the 2 key to put the current call on hold and accept the waiting call. Call
hold service must be enabled for this to work.
• Press flash-hook, followed by the 1 key to terminate the current call and accept the waiting call
• Go on-hook to terminate the current call. The terminal will ring to indicate that a call is waiting—when
this call is accepted by going off-hook again, the waiting call is connected.
Making a second call while holding first call
To make a second call while the current call is active, you will put the current call on hold, then make your sec-
ond call.
Procedure: To make a second call to another party while keeping the current call, press flash-hook which puts
your current call on-hold and provides you a dialtone for the second call. After hearing the dialtone, you may
dial your second call.
To toggle between the active call and the call on-hold, press flash-hook, then press the 2 key on the
telephone set
Note
Call holding service must be enabled for this procedure to work.
Action
Press flash-hook, then press 0 The waiting call is rejected.
Press flash-hook, then press 1 This drops the current call and accepts the incoming waiting call.
Press flash-hook, then press 2 If you have another call on-hold, this action toggles from the current call
Press flash-hook, then press 2 If you hear the waiting tone (to indicate a new incoming call), this action
Press flash-hook and wait for
dialtone
FXS supplementary services description
Table 10. Command Summary
to the on-hold call.
toggles to the waiting call and puts the current call to be on-hold.
If you want to make a second outgoing call, this action puts the current
call on-hold and provides you dial-tone for making another call. Once
the call is made, you can toggle between the calls by using the flash-
hook, 2 action.
29 • FXS interface configuration
Result
343