Configuration Of Terminal Sessions - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Administrator execution
Step Command
node #show crc filename
1
Example:
Displaying the
The following example shows how to display the checksum of the configuration test of your device, if you start
from the configuration mode.
node#show crc nvram:test
File nvram: test:
checksum: 0xfaddc88a
Configuration of terminal sessions
In certain cases it may be desirable to change the settings of the current terminal session.
Mode: System
Step
[ name ] (sys)#terminal height
1
[ name ] (sys)#[no] terminal idle-time-
2
logout
[ name ] (sys)#terminal more
3
[ name ] (sys)#terminal width
4
When there are many VoIP units in the same location, use this command to flash all the LED's on a specific
unit for a specified period of time. This makes identification of the physical unit very easy.
Step
[ name ] #blink <seconds>
1
Basic system management configuration task list
Displays checksum of a configuration
checksum of a configuration
Command
Command
7 • Basic system management
Purpose
Purpose
Configures the terminal height.
After 30 minutes without user input, a terminal session
is automatically closed. If longer session periods are
required (logging/debugging) this command allows
to increase the session timeout, or to disable it com-
pletely.
Enables pausing of display for commands which pro-
duce more output than the current terminal window
can display at once.
Configures the terminal width.
Purpose
Enter an integer for the period of time you want the
LED's to flash on the physical unit.
93