Command Line Interface (Cli); Accessing The Cli; System Image Handling; Configuration File Handling - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
• Chapter 3,

"Command line interface (CLI)"

that allow you to navigate the CLI and edit commands effectively.
• Chapter 4,

"Accessing the CLI"

the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
• Chapter 5, "Establishing basic IP connectivity"
nections to and from your SmartNode by using IP interfaces and Ethernet ports.
• Chapter 5,

"System image handling"

driver software.
• Chapter 6, "Configuration file handling"
files from and to a SmartNode.
• Chapter 7,

"Basic system management"

tion to the operator or administrator, and their configuration.
• Chapter 8, "RADIUS Client Configuration"
rization, and accounting (AAA) component in SmartWare and describes how to configure the RADIUS cli-
ent, a subpart of the AAA component.
• Chapter 9,

"IP context overview"

with its related components.
• Chapter 10, "IP interface configuration"
and describes the tasks involved in their configuration.
• Chapter 11, "NAT/NAPT configuration"
port translation and describes the tasks involved in its configuration.
• Chapter 12, "Ethernet port configuration"
describes the tasks involved in their configuration through SmartWare.
• Chapter 13, "Link scheduler configuration"
quality of service (QoS) features.
• Chapter 14, "Serial port configuration"
the tasks involved in its configuration through SmartWare.
• Chapter 15, "T1/E1 port configuration"
acteristics and the tasks involved in the configuration.
• Chapter 16, "Basic IP routing configuration"
the tasks involved in configuring static IP routing in SmartWare.
• Chapter 17, "RIP configuration"
(RIP) and describes the tasks involved in configuring RIP features within SmartWare.
• Chapter 18, "Access control list configuration"
and describes the tasks involved in their configuration through SmartWare.
• Chapter 19, "SNMP configuration"
simple network management protocol (SNMP) and describes the tasks used to configure those of its features
supported by SmartWare.
on page 44 gives an overview of the CLI and the basic features
on page 48 describes the procedures for entering SmartWare commands via
on page 68 explains how to establish network-based con-
on page 59 describes how to load and maintain system images and
on page 69 describes how to upload and download configuration
on page 83 describes parameters that report basic system informa-
on page 94 provides an overview of the authentication, autho-
on page 105 outlines SmartWare Internet protocol (IP) context, together
on page 111 provides a general overview of SmartNode interfaces
on page 122 provides a general overview of the network address
on page 131 provides an overview of Ethernet ports and
on page 141 describes how to use and configure SmartWare
on page 160 provides an overview of the serial port and describes
on page 179 provides an overview of the T1/E1 ports, their char-
on page 189 provides an overview of IP routing and describes
on page 196 provides an overview of the routing information protocol
on page 206 provides an overview of IP access control lists
on page 220 on page 238 provides overview information about the
About this guide
27