Patton electronics SmartWare R.3.20 Software Configuration Manual page 477

SmartWare Software Configuration Guide
Mode: Configure
Step
node (config)#port fxo slot port
1
node (prt-fxo)[ slot / port ]#caller-id for-
2
mat { bell | etsi }
optional
node (prt-fxo) [ slot / port ]#flash-hook
3
duration duration
optional
Other FXO port parameters
Command Purpose
Enter FXO port configuration mode
Specifies which line protocol is used for caller-id
transmission. Use bell for US / Canada, etsi for
Europe.
If caller-id is not enabled or wrong configured,
detection of caller-id is not possible. Default: etsi
Specifies for what time the SmartNode should go
on-hook to signal flash-hook to the CO. Default of
duration is 200ms, for US and Canada try 350ms
or higher.
37 • FXO port configuration
477