Patton electronics SmartWare R.3.20 Software Configuration Manual page 159

SmartWare Software Configuration Guide
The command has optional values (in the range of 1 to 4) that define the level of detail (see
Note The debug features offered by SmartWare require the CPU resources of your
SmartNode. Therefore do not enable statistic gathering or other debug fea-
tures if it is not necessary. Disable any debug feature after use with the
form of the command.
You can enable queue statistics for all queues of a link scheduler by placing the
mand in the profile header. Queue statistics are reset whenever the configuration is changed or SmartWare is
reloaded.
Mode: Source
Step
node (src)[ name ]#debug queue statistics level Enables statistic gathering for the selected class
1
Example: Enable statistics gathering for all queues of a profile
The following example shows how to enable statistic gathering for all traffic-classes
node>enable
node#configure
node(cfg)#profile service-policy sample
node(pf-srvpl)[sample]#debug queue statistics 4
Link scheduler configuration task list
Table 7. Values defining detail of the queuing statistics
Optional Value Implication on Command Output
0 Statistic gathering is switched off
1 Display amount of packets passed (did
not have to wait), queued (arrived ear-
lier than rate permitted) and discarded
(due to overflowing queue)
2 Also collects byte counts for the catego-
ries listed above
3 Also keeps track of the peek queue
lengths ever reached since the last con-
figuration change or reload
4 Adds delay time monitoring
Command
13 • Link scheduler configuration
debug queue statistics
Purpose
or policy name . The optional argument level ,
which is in the range from 1 to 4, defines the ver-
bosity of the command output.
table 7).
no
com-
159