Patton electronics SmartWare R.3.20 Software Configuration Manual page 419

SmartWare Software Configuration Guide
The following table shows the different digit-collection timeout configurations and their effect on a T-termi-
nated route when the digit-collection timeout elapses. Important settings are marked bold.
Digit Collection Timeout
Configuration
Timeout append-
terminating-
char
no no
yes
yes no
yes
The command digit-collection terminating-char <char> has been extended with two optional arguments that
specify whether the terminating-character is re-appended or the address-complete indication is set when a
digit-collection timeout is stopped by the user sending the terminating-character. The new command syntax is:
[no] digit-collection terminating-char <char> [append-terminating-char] [set-address-complete-indication]
The extensions configure what action(s) shall be performed when the digit-collection timeout is stopped by the
reception of a terminating-character. Normally, without specifying an action, the received terminating-charac-
ter is removed from the called-party number. The append-terminating-char action re-appends the terminat-
ing-character. The set-address-complete-indication action sets the address-complete indication. Whether or
Call router configuration task list
Ingress Properties
set-address- called-e164
complete-
indication
no 123
yes
no
yes
no
yes
no
yes
33 • Call router configuration
Egress Properties (Result
Address- called-e164
Complete
Indication
false no call
true
false
true
false
true
false
true
false 123
true
false
true
false
123#
true
false
true
of call-routing)
Address-
Complete
Indication
false
true
true
true
false
true
true
true
419