Patton electronics SmartWare R.3.20 Software Configuration Manual page 66

SmartWare Software Configuration Guide
Note the placeholder used in the file location. Placeholders can be used for each part of the location, be it
server address, path or filename. The following place holders are available:
• $(system.mac)—MAC address of ETH 0/0 (without ":" between the hexadecimal characters)
• $(system.serial)—serial number of the unit
• $(dhcp.66)—DHCP option 66 (TFTP server IP), as delivered by the DHCP server (only if DHCP
is enabled)
• $(dhcp.67)—DHCP option 67 (Boot file name), as delivered by the DHCP server (only if DHCP
is enabled)
To use and debug provisioning:
Step
1 [name] (cfg)provisioning execute FIRMWARE
2 [name] (cfg)debug provisioning
To continuously poll for firmware or configuration changes, use the
with the new command as described below. Here's how to do both firmware and configuration provi-
timer
sioning, with a polling interval of 10 minutes.
Auto provisioning of firmware and configuration
Command
5 • System image handling
Purpose
Executes the provisioning profile
FIRMWARE once
Enables debug output for all
provisioning operations
provisioning execute
command together
66