Enable The Session Timer (Optional); Advanced Configuration Options (Optional); Changing The Listening Port For Inbound Call-Signaling; Define Session Timer Version - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Interface SIP
Step
1 [ name ] (if-sip)# [no] remote-Party-ID

Enable the session timer (optional)

The gateway implements the SIP session timer feature, which is currently only defined in SIP draft standards.
The session timer feature allows a gateway to check periodically during a call, if the remote gateway is still alive
and if the call is still connected on the remote gateway. You can enable this feature using the command shown
below. If the session timer feature detects that the call is no longer connected on the remote side, it will also
drop the call locally.
Mode: Gateway SIP
Step
1 node (gw- sip )[ sip ]#session-timer seconds
Example: Enabling the session timer feature
The following example shows how to enable the session timer feature, with a refresh period of 1200 seconds.
node(cfg)#gateway sip sip
node(gw-sip)[sip]#session-timer 1200
Advanced configuration options (optional)

Changing the listening port for inbound call-signaling

The default UDP/TCP listening port for inbound call-signaling connections is per default 5060 as defined in
the SIP standard. The following procedure describes how to change the port number.
Mode: Gateway SIP
Step
1
node (gw-sip)[hsip]#call-signaling-port port
Example: Defining an alternate call-signaling port
The following example shows how to define an alternate call-signaling port on an already defined SIP Gateway.
node(cfg)#gateway sip sip
node(gw-sip)[sip]#call-signaling-port 5061
Define session timer version
There is currently no final standard available for the implementation of the session timer feature in SIP. How-
ever different versions of draft standard implementations are used in current SIP products. For compatibility
with current SIP equipment, the gateway supports two different versions of the session-timer draft standard.
Gateway configuration task list
Command
Command
Command
39 • SIP gateway configuration
Purpose
Enables or disables support for the SIP
Remote-Party-ID header
Purpose
Enable the session timer with a refresh period
of the specified number of seconds.
Purpose
Defines the UDP/TCP port to use for inbound
call-signaling connections
498