Activate The Call Router Configuration - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Context CS
Step Command
node (ctx-cs)[ switch ]#no service service-
1
name
Example: Remove an entire mapping table
node(cfg)#context cs
node(ctx-cs)[switch]#no service HUNT-BRI
Activate the call router configuration
Prior to activate the call router configuration you can show the whole context CS configuration and the entire
call routing tables.
The call router configuration is activated as soon as the CS context comes out of shutdown (e.g. at boot time or
by manually entering command
active after 3 seconds. SmartWare offers a number of possibilities to monitor and debug the CS context and
call router configurations. For more information refer to chapter 42,
Note
It is not necessary to shutdown the CS context prior to making any configu-
ration changes.
Procedure: To show and activate the call router configuration
Mode: Context CS
Step Command
1 node (ctx-cs)[ switch ]#show call-router
config
2 node (ctx-cs)[ switch ]#show running-
config
3 node (ctx-cs)[ switch ]#debug call-
router detail level
4 node (ctx-cs)[ switch ]#no shutdown
5 node (ctx-cs)[ switch ]#show call-router
status
Note
Unlike previous versions of SmartWare you must explicitly enter the
shutdown
Call router configuration task list
Delete the service service-name .
Note:
just deleting it. The type must only be specified when creating
a service.
). You can modify the configuration at runtime; changes will be
no shutdown
Show the actual call router configuration. This displays all
routing and mapping tables in the current context CS. When
you are inside a routing or mapping table configuration
mode, only the current table is displayed.
Show the whole running config includes the call routing
tables
Enable the call router debug monitor. Use level 1 for get
informed about errors and increase the level up to 5 to track
calls during route lookups.
Activate the whole CS context configuration including the call
router configuration.
Show the actual call router status. This command can be used
to examine whether or not the call router accepted all routing
entries as entered in the configuration.
command to activate the call router.
33 • Call router configuration
Purpose
You do not have to enter the type of the service when
"VoIP debugging"
Purpose
on page 532.
no
439