Enable Tone-Set Profile - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Procedure: To configure a tone-set profile
Mode: Configure
Step
1
node (cfg)#profile tone-set name
2
node (pf-tones)[ name ]#map
call_progress_tone
{
busy-tone |
confirmation-tone|
congestion-tone |
dial-tone |
hold-tone |
release-tone |
ringback-tone |
special-dial-tone |
special-information-tone |
waiting-tone
} call-progress-tone
3
Example: Configuring a tone-set
The following example shows how to configure a tone-set profile for UK.
node(cfg)#profile tone-set UK
node(pf-tones)[UK]#map call_progress_tone dialtone dialUK
node(pf-tones)[UK]#map call_progress_tone alertingtone ringUK
node(pf-tones)[UK]#map call_progress_tone busytone busyUK
Enable tone-set profile
A call on the SmartNode always has two signaling protocol endpoints. At the moment it is only possible to
play locally generated tones on PSTN endpoints (ISDN, FXS) and not on IP based signaling endpoints
(H.323, SIP, MGCP). Dependent on the configuration several combinations of signaling protocol endpoints
are possible (ISDN–ISDN, H.323-ISDN, FXS-SIP etc.). The SmartNode will always generate the tones
locally and play it on the PSTN line as long as the other endpoint doesn't notifies availability of inband infor-
mation and the PSTN endpoint is NOT of type ISDN-USER or FXO. If availability of inband information
will be notified by one endpoint, the bearer channel already contains the necessary tone information and must
not be generated locally.
If the user has not specified a tone-set profile, the default tone-set will be taken to generate the local inband
information. For enabling a user defined tone-set profile on a specific interface proceed as follows.
Procedure: To assign a tone-set profile to a PSTN interface
Tone configuration task list
Command
34 • Tone configuration
Purpose
Creates tone-set name and enters tone-set pro-
file configuration mode.
Map a call-progress-tone profile to an internal
tone. An internal tone represents the call event
for which a tone indication can be provided.
Use the CLI help to get a list of all available
events.
Repeat step 2 for all internal tone events.
450