Setting Time And Date; Display Clock Information - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Setting the system banner
The following example shows how to set a message for the system banner for your device, if you start from the
configuration mode.
node(cfg)#banner \n#\n# The password of all operators has changed\n# please contact
the administrator\n#"

Setting time and date

All SmartNode devices provide time-of-day and date services. These services allow the products to accurately
keep track of the current time and date. The system clock specifies year, month, day, hour, minutes, and
optionally seconds. The time is in 24-hour format yyyy-mm-ddThh:mm:ss and is retained after a reload.
Mode: Configure
Step
node (cfg)#clock set yyyy-mm-ddThh:mm:ss
1
Note The integrated SNTP client allows synchronization of time-of-day and date
to a reference time server. Refer to chapter 20,
on page 235 for more details.
Example: Setting time and date
The following example shows the commands used to set the system clock of your device to August 6, 2001 at
16:55:57, if you start from the operator execution mode.
node(cfg)#clock set 2001-08-06T16:55:57

Display clock information

This procedure describes how to display the current date and time
Mode: Both in operator and administrator execution
Step Command
node >show clock
1
Example: Display clock information
The following example shows the commands used to display the time and date settings of your device in local
time, if you start from the operator execution mode.
node>show clock
2001-08-06T16:55:57
Basic system management configuration task list
Command
Display the local time.
7 • Basic system management
Purpose
Sets the system clock to yyyy-mm-ddThh:mm:ss
"SNTP client configuration"
Purpose
88