Configuring Ethernet Encapsulation Type For An Ethernet Port; Binding An Ethernet Port To An Ip Interface - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Configuring medium for an Ethernet port
The following example shows how to configure medium auto-sense for the Ethernet port on slot 0 and port 0
of a SmartNode 4524 device.
node(cfg)#port ethernet 0 0
node(prt-eth)[0/0]#medium auto
Configuring Ethernet encapsulation type for an Ethernet port
This procedure describes how to configure the encapsulation type to IP for the Ethernet port on slot and port.
Mode: Configure
Step
node (cfg)#port ethernet slot port
1
node (prt-eth)[ slot/port ]#encapsulation ip
2
Example: Configuring Ethernet encapsulation type for an Ethernet port
The following example shows how to configure the encapsulation type to IP for the Ethernet port on slot 0 and
port 0.
node(cfg)#port ethernet 0 0
node(prt-eth)[0/0]#encapsulation ip

Binding an Ethernet port to an IP interface

You must bind the Ethernet port to an existing IP interface. When executing the
requested interface must exist. If no IP context is given, the system attaches the interface to the default IP con-
text known as router.
Ethernet port configuration task list
Command
12 • Ethernet port configuration
Purpose
Enters Ethernet port configuration mode for the
interface on slot and port .
Configures the encapsulation type to IP.
bind command, the
133