Patton electronics SmartWare R.3.20 Software Configuration Manual page 263

SmartWare Software Configuration Guide
16:20:43
16:20:43
16:20:43
16:20:44
16:20:44
If required, you can force the DynDNS component to re-register the current IP address on the DynDNS
server—even if the dynamic IP address has not changed—using the following command (this command could
also be useful for observing the update process in the debug monitor).
IMPORTANT
You can also force the DynDNS client to resume normal operation, if the state of the DynDNS client is shown
as blocked and the problem which led to the blocked state has been solved. The DynDNS client will enter the
blocked state if the DynDNS server reports an unrecoverable error during DNS updates that require user inter-
vention. These are mainly configuration problems, such as invalid credentials or an invalid hostname.
Mode: DynDNS
Step Command
1 node(dyndns)#dyndns reset
DynDNS configuration task list
DYNDNS> Resolved 'update.dyndns.org'.
DYNDNS> Updating DNS...
DYNDNS> Sending request...
DYNDNS> DNS updated successfully
DYNDNS> Registered IP address is (57.32.59.64).
Possible blocking—Do not use this command too often,
because the DynDNS server will block your hostname, if you
trigger too many unnecessary updates of your IP address.
Forces a re-registration of the current IP address on the
DynDNS server, even if an update is not necessary
23 • DynDNS configuration
Purpose
263