Patton electronics SmartWare R.3.20 Software Configuration Manual page 429

SmartWare Software Configuration Guide
Class
Invalid Message
call-identity-in-use
(Cont.)
no-call-suspended
call-has-been-cleared
incompatible-destination Drop original call
invalid-transit-network
invalid-message
mandatory-ie-missing
Protocol Error
message-type-not-imple-
mented
message-type-not-state-
compatible
Call router configuration task list
Table 16. Hunt group drop causes (Continued)
Default Behavior
Cause of the Hunt
Group Service
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
33 • Call router configuration
Description
This cause indicates that the network has
received a call suspends request. The call
suspend request contained a call identity
which is already in use for a suspended
call within the domain of interfaces over
which the call might be resumed.
The network receives a call resume request
when there is not a suspended call pend-
ing. This can be a transient error that will
be resolved by successive call retries.
The network receives a call resume
request. This call resume request contains
a call identity that once indicated a sus-
pended call. However, the suspended call
was cleared either by time-out or by the
remote user.
Indicates that an attempt is made to con-
nect incompatible equipment.
This cause indicates that a transit network
identification of an incorrect format was
received.
Received an invalid message with no stan-
dard cause.
The receiving equipment receives a
message that does not include one of the
mandatory information elements. This
cause indicates that the equipment
sending this cause has received a
message that is missing a call property
that must be present in the message before
that message can be processed.
The receiving equipment receives an
unrecognized message, because the mes-
sage type is invalid or the message type is
valid but not supported.
The remote equipment receives an invalid
message with no standard cause. This
cause indicates that the equipment send-
ing this cause has received a message
such that the procedures do not indicate
that this is a permissible message to
receive while in the current call state.
429