SmartWare Software Configuration Guide
Step
4
[ name ] (gw-svc)[<svc-name>]#
authentication
•
call-transfer-version
•
contact-address
•
default-server
•
domain
•
nat-traversal
•
new-session-after-redirect
•
registrar
•
registration-lifetime
•
session-timer
•
session-timer-version
•
use
•
Repeat steps 3 & 4 for each additional service you want to use.
5
6
[ name ] (gw-svc)[<svc-name>]# context cs
7
[ name ] (ctx-cs)[switch]# interface sip <if-name>
8
[ name ] (if-sip)[<if-name>]# bind gateway <gw-
name>
9
[ name ] (if-sip)[<if-name>]# service <service-name>
10
[ name ] (if-sip)[<if-name>]#
address-translation
•
early-connect
•
early-disconnect
•
phone-context
•
remote
•
remote-party-id
•
route
•
use
•
Repeat steps 7 to 10 for each additional service, you want to use.
11
Configuring multiple SIP services on a SIP gateway
Command
39 • SIP gateway configuration
Purpose
Configure all necessary parameters for
your service using the service com-
mands shown in the previous column.
A detailed description of these com-
mands can be found in the Software
Configuration Guide.
Change to the context cs mode.
Create a SIP interface for your service
Bind the interface to your SIP gateway
Define the service within your gate-
way to use for this interface
If required, configure additional
parameters for your interface using the
interface commands shown in the pre-
vious column. A detailed description
of these commands can be found in
the Software Configuration Guide.
505