Deleting An Ip Interface - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Create IP interfaces
The procedure illustrated below assumes that you would like to create an IP interface named lan Use the fol-
lowing commands in administrator configuration mode.
node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#

Deleting an IP interface

Almost every configuration command has a
tion. Use the command without the
disabled by default.
Deleting an existing interface in the IP context is often necessary.
Mode: Context IP
Step
node (ctx-ip)[router]#no interface name Deletes the existing interfaces name
1
Example: Delete IP interfaces
The procedure below assumes that you would like to delete an IP interface named external. Use the following
commands in IP context configuration mode.
List the existing interfaces:
node(ctx-ip)[router]#interface <?>
<interface>
lan
wan
external
internal
Delete the interfaces named eth3 with the
node(ctx-ip)[router]#no interface external
List the interfaces again to check if the appropriate interface was deleted:
node(ctx-ip)[router]#interface <?>
<interface>
lan
wan
internal
IP interface configuration task list
no
keyword to re-enable a disabled feature or to enable a feature that is
no
Command
New interface
Existing interface
Existing interface
Existing interface
Existing interface
no interface
New interface
Existing interface
Existing interface
Existing interface
form. In general, use the
command:
10 • IP interface configuration
no form to disable a feature or func-
Purpose
113