Creating/Modifying An Outgoing Acl Profile For Ipsec - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Create an IPsec policy profile
The following example defines a profile for AES-encryption at a key length of 128.
node(cfg)#profile ipsec-policy-manual ToBerne
node(pf-ipsma)[ToBerne]#use profile ipsec-transform AES_128
node(pf-ipsma)[ToBerne]#session-key inbound esp-encryption
1234567890ABCDEF1234567890ABCDEF
node(pf-ipsma)[ToBerne]#session-key outbound esp-encryption
FEDCBA0987654321FEDCBA0987654321
node(pf-ipsma)[ToBerne]#spi inbound esp 1111
node(pf-ipsma)[ToBerne]#spi outbound esp 2222
node(pf-ipsma)[ToBerne]#peer 200.200.200.1
node(pf-ipsma)[ToBerne]#mode tunnel
Creating/modifying an outgoing ACL profile for IPsec
An access control list (ACL) profile in the outgoing direction selects which outgoing traffic to encrypt and/or
authenticate, and which IPsec policy profile to use. IPsec does not require an incoming ACL.
Note
Outgoing and incoming IPsec traffic passes an ACL (if available) twice, once
before and once after encryption/authentication. So the respective ACLs
must permit the encrypted/authenticated and the plain traffic.
For detailed information on how to set-up ACL rules, see chapter 18,
page 206.
Procedure: To create/modify an outgoing ACL profile for IPsec
Mode: Configure
Step
node (cfg)#profile acl name
1
node (pf-ipstr)[ name ]#permit ...
2
[ ipsec-policy name ]
Note
New entries are appended at the end of an ACL. Since the position in the list
is relevant, you might need to delete the ACL and rewrite it completely.
Example: Create/modify an ACL profile for IPsec
The following example configures an outgoing ACL profile that interconnects the two private networks
192.168.1/24 and 172.16/16.
node(cfg)#profile acl VPN_Out
node(pf-acl)[VPN_Out]#permit ip 192.168.1.0 0.0.0.255 172.16.0.0 0.0.255.255 ipsec-
policy ToBerne
node(pf-acl)[VPN_Out]#permit ip any any
VPN configuration task list
Command
"Access control list configuration"
Purpose
Creates or enters the ACL profile name
The expression 'ipsec-policy name' appended to a
permit ACL rule activates the IPsec policy profile
name to encrypt/authenticate the traffic identified
by this rule.
25 • VPN configuration
on
286