Showing Sntp Client Related Information; Debugging Sntp Client Operation - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Disabling the SNTP client root delay compensation
node(cfg)#no sntp-client root-delay-compensation

Showing SNTP client related information

During set-up and operation of the SNTP client, displaying the information and status of the SNTP client is
very useful.
This procedure describes how to display information and status of the SNTP client
Mode: Configure
Step Command
node (cfg)#show sntp-client Displays information and status of the SNTP client
1
Example: Showing SNTP client related information
node(cfg)#show sntp-client
-------------------------------------------
SNTP client
Operating mode
Local port
Primary server
Secondary server
Anycast address
Poll interval
Local clock offset disabled
GMT offset
-------------------------------------------

Debugging SNTP client operation

During setup and operation, debugging the behavior of the SNTP client is very useful.
Note
The debug sntp client is only available in superuser mode.
This procedure describes how to enable or disable debugging
Mode: Configure
Step Command
node (cfg)#debug sntp client Enables and disables SNTP debug monitor. Using the no com-
1
SNTP client configuration task list
enabled
unicast
123
172.16.1.10:123 v4
128.138.140.44:123 v4
224.0.1.1:123
30sec
+2:00:00
mand syntax disables this feature.
20 • SNTP client configuration
Purpose
Purpose
242