Patton electronics SmartWare R.3.20 Software Configuration Manual page 169

SmartWare Software Configuration Guide
This procedure describes how to enable Frame Relay fragmentation
Mode: Frame Relay
Step Command
node (cfg)#port serial slot port
1
node (prt-ser)[ 0/0 ]#framerelay
2
node (frm-rel)[ 0/0 ]#use profile
3
service-policy name out
node (frm-rel)[ 0/0 ]#fragment size Defines the maximum size (in Bytes) of the Frame Relay pay-
4
node (frm-rel)[ 0/0 ]#pvc dlci
5
node (pvc)[ dlci ]#fragment size
6
Note
For proper functioning, do not specify a scheduler mode (burst-shaper,
burst-WFQ, shaper, WFQ) for the Frame Relay service policy profile. Fur-
thermore, do not use the Frame Relay service policy profile on the IP layer,
but rather on the Frame Relay layer (mode framerelay). Make sure voice traf-
fic is being given priority over data (command
voice priority
Note
FRF.12 end-to-end fragmentation and FRF.12 interface fragmentation are
incompatible. Thus make sure that both ends of a Frame Relay link run the
same fragmentation mode.
Note
When running data and voice over a Frame Relay link, it is advisable to only
configure fragmentation for the PVC that carries data traffic. This way, frag-
mentation protocol overhead and fragmentation processing overhead is only
spent for data traffic—voice packets (whose length should be smaller than the
fragmentation length) do not consume processing power and protocol over-
head for fragmentation.
The purpose of end-to-end FRF.12 fragmentation is to support real-time and non-real-time data packets on
lower-speed links without causing excessive delay to the real-time data. The FRF.12 Implementation Agree-
ment defines FRF.12 fragmentation. This standard was developed to allow long data frames to be fragmented
into smaller pieces (fragments) and interleaved with real-time frames. In this way, real-time and non-real-time
data frames can be carried together on lower-speed links without causing excessive delay to the real-time traffic.
End-to-end FRF.12 fragmentation is recommended for use on permanent virtual circuits (PVCs) that share
links with other PVCs transporting voice and on PVCs transporting Voice over IP (VoIP).
Serial port configuration task list
Selects the serial interface on slot and port.
Enters Frame Relay configuration mode.
Uses the previously defined service policy profile on Frame
Relay layer (and not on IP interface level) in outward direc-
tion.
load (excluding Frame Relay header and trailer overhead)
for all PVCs (FRF.12 interface fragmentation).
See also the table below
Enters the PVC configuration mode by assigning a DLCI num-
ber to be used on the specified virtual circuit.
Defines the maximum size (in bytes) of the Frame Relay pay-
load (excluding Frame Relay header and trailer overhead)
for this PVC only (FRF.12 end-to-end fragmentation).
See also the table below
).
14 • Serial port configuration
Purpose
source class local-
169