SmartWare Software Configuration Guide
Mode: q921
Step
1
node (q921)[slot/port]#protocol pp
or
node (q921)[slot/port]#protocol pmp
2
node (q921)[slot/port]#uni-side auto
or
node (q921)[slot/port]#uni-side net
or
node (q921)[slot/port]#uni-side user
3
node (q921)[slot/port]#[no] permanent-
layer2
4
node (q921)[ slot/port ]#encapsulation
q931
5
node (q921)[ slot/port ]#q931
Configure ISDN layer 3 parameters (Q931)
ISDN Layer 3 (Q931) settings apply to both BRI and PRI ports. They are defined in the q931 mode. To use
Q931, the layer 2 encapsulation must be set to q931.
Note
QSIG is an ISDN based protocol for signaling between nodes of a Private
Integrated Services Network. The formal name of the signaling system by
ISO / IEC is PSS1. Both names will co-exist and QSIG will continue to be
used as the marketing name.
ISDN port configuration task list
Command
35 • ISDN port configuration
Purpose
Specify ISDN layer 2 operating mode
(Default: BRI: pmp, PRI: pp).
The ISDN layer 2 of BRI ports can operate in
point-to-point (pp) or point-to-multipoint (pmp)
mode. Point-to-multipoint is used to connect
multiple terminals to an ISDN S-Bus. In some
cases small PBXs are also connected to the
public ISDN in point-to-multipoint mode. Point-
to-point is typically used to connect PBXs to a
public or private ISDN.
PRI ports always run in point-to-point (pp)
mode.
Specify the UNI side of the interface (Default:
auto)
If layer1 clock mode is not defined or set to
auto this setting also specifies the clock mode
for layer1.
NET: clock mode = master
USR: clock mode = slave
If set to auto the UNI side setting is taken from
layer3.
Enables the ISDN Layer 2 permanently
(Default: disabled).
By default, the ISDN Layer 2 is not enabled
permanently, i.e. the first call enables it.
(Currently only available with IC-T1V)
Specify the ISDN layer 3 protocol (Default:
q931)
Currently only Q931 is supported.
The no form of the command removes an
existing encapsulation.
Enter Q931 configuration mode.
463