Configuring Caller-Id Presentation (Optional); Configuring Call Holding Supplementary Service (Optional) - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
There is a PSTN profile named default, which always exists in the system. If no different PSTN profile name is
explicitly configured on the FXS interface, the profile named default is used.
Procedure: To define an alternate PSTN profile for the FXS interface
Mode: Interface FXS
Step
1 node (if-fxs)[ if-name ]#[no] use profile pstn
profile-name
Example: Configure an alternate PSTN profile
The following example shows how to replace the PSTN profile named default of the FXS interface by an alter-
nate PSTN profile named myprofile.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxs myFxsIf
node(if-fxs)[myFxsIf]#use profile pstn myprofile
Configuring caller-ID presentation (optional)
POTS protocols allow the presentation of the caller-ID (calling party number and name of an incoming call)
to an analog terminal when the terminal is ringing. (See also chapter 36,
for other caller-ID related settings.)
Procedure: To configure presentation of the calling party number to the analog device connected to the FXS
port associated with the interface
Mode: Interface FXS
Step
1
node (if-fxs)[ if-name ]#[no] caller-id-pre-
sentation {pre-ring|mid-ring}
Example: Enable the caller-ID presentation after the first ring
The following example shows how to enable caller-ID
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxs MyFxsIf
node(if-fxs)[myFxsIf]#caller-id-presentation mid-ring
Configuring call holding supplementary service (optional)
The call holding supplementary service can be administratively enabled or disabled. If disabled, the user doesn't
have the possibility to have two calls at the same time on an FXS interface.
FXS interface configuration task list
Command
Command
29 • FXS interface configuration
Purpose
Defines an alternate PSTN profile to be used for this
FXS interface/Reverts the setting to its default (use
profile PSTN default )
"FXS port configuration"
Purpose
Enables/Disables presentation of the caller ID, and
configures the time when caller ID is presented on
the line.
on page 469
345