Navigating The Cli; Initial Mode; System Changes; Configuration - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide

Navigating the CLI

Initial mode

When you initiate a session, you can log in with operator or administrator privileges. Whichever login you use,
the CLI is always set to operator exec (non-privileged exec) mode by default upon startup. This mode allows
you to examine the state of the system using a subset of the available CLI commands.

System changes

In order to make changes to the system, the administrator exec (privileged exec) mode must be entered. The
user interface command is used for this purpose (the
enable
logged in as an administrator). Once in administrator exec mode, all of the system commands are available to
you.
Configuration
To make configuration changes, the configuration mode must be entered by using the
the administrator exec mode.

Changing Modes

The command moves the user up one level in the mode hierarchy (the same command works in any of
exit
configuration modes). For example, when in pvc configuration mode, typing
configuration mode.
The command terminates a CLI session when typed from the operator exec mode.
exit
A session can also be terminated by using the

Command editing

Command help

To see a list of all CLI commands available within a mode, type a question mark <?> or the <tab> key at the
system prompt in the mode of interest. A list of all available commands is displayed. Commands that have
become available in the current mode are displayed at the bottom of the list, separated by a line. Commands
from higher hierarchy levels are listed at the top.
You can also type the question mark or the <tab> key while in the middle of entering a command. Doing so
displays the list of allowed choices for the current keyword in the command. Liberal use of the question mark
functionality is an easy and effective way to explore the command syntax.

The No form

Almost every command supports the keyword
function or "deletes" a command from the configuration. For example, to enable the DHCP server trace tool,
enter the command
debug dhcp-server
no debug dhcop-server

Command completion

You can use the <tab> key in any mode to carry out command completion. Partially typing a command name
and pressing the <tab> key causes the command to be displayed in full up to the point where a further choice
has to be made. For example, rather than typing
Command editing
logout
no
. To subsequently disable the DHCP server trace, enter the command
.
configure
command is only accessible if you are
enable
command within any mode.
. Typing the no keyword in front of a command disables the
, typing and pressing the <tab> key causes the
conf
3 • Command line interface (CLI)
command in
configure
will take you to framerelay
exit
46