Isdn Port Configuration Task List; Shutdown And Enable Isdn Ports; Configure Bri Port Parameters (Layer 1) - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
ISDN port configuration task list
Configuring ISDN ports typically consists of the following tasks:
•

Shutdown and enable ISDN ports

• Configure ISDN layer 1 parameters for BRI ports
• Configure ISDN layer 1 parameters for PRI ports
• Configure ISDN layer 2 parameters
• Configure ISDN layer 3 parameters
Shutdown and enable ISDN ports
By default all ISDN ports are initially shutdown.
Procedure: To disable and activate an ISDN port
Mode: Port {bri|e1|t1}
Step
1
node (cfg)#port bri slot port
2
node (prt-bri)[ slot / port ]#shutdown
3
node (prt-bri) [ slot / port ]#no shutdown
Example: Shutting down and enabling an ISDN port
The following example shows how to enter the configuration mode for BRI port 0/0, disable and activate the
port.
172.16.40.71>enable
172.16.40.71#configure
172.16.40.71(cfg)#port bri 0 0
172.16.40.71(prt-bri)[0/0]#shutdown
If required change the configuration here.
172.16.40.71(prt-bri)[0/0]#no shutdown
Configure BRI port parameters (Layer 1)
For a BRI port the only layer 1 setting that can be specified is the clock mode. To work with the port a layer 2
protocol must be bound to it. This is done be specifying an encapsulation.
Procedure: To configure BRI port parameters.

ISDN port configuration task list

Command
35 • ISDN port configuration
Purpose
Enter port configuration. Port type can either
be bri, e1 or t1 depending on the installed
hardware.
Shutdown the port. All active calls are
dropped!
Activate the port.
460