Patton electronics SmartWare R.3.20 Software Configuration Manual page 354

SmartWare Software Configuration Guide
Mode: Interface FXO
Step
1 node>
2 node>enable
node#
3 node#configure
node(cfg)#
4 node(cfg)#context cs
node(ctx-cs)[switch]#
node(ctx-cs)[switch]#interface fxo if-name
5
node(if-fxo) [if-name] #
node(if-fxo) [if-name] #dial-after {dial-tone | timeout seconds } Specifies whether to dial
6
Example: Setting the timeout to be 4 seconds after going off-hook when initiating a call. The timeout is set for
the FXO interface named Line0.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxo Line0
node(if-fxo)[Line0]#dial-after timeout 4
You can verify the change in configuration by using the
This is one of the few commands that does not have a
change the timeout period, re-enter the command with the new timeout period. The other option is to wait
for dial-tone. To return to the default (waiting for dial-tone before dialing), enter the command again
using .
dial-tone
FXO interface configuration task list
Prompt, command & response
30 • FXO interface configuration
show running-config
inverse operation of the command. If you want to
no
Purpose
Basic prompt in Operator
Exec mode
Enters Administration execu-
tion mode
Response: The prompt in
administration execution
mode is the #
Enters the Configure configu-
ration mode
Response: The prompt in the
Configure configuration
mode is (cfg)#
Enters the Context CS config-
ure mode
Response: The prompt in the
Context CS configuration
mode is (ctx-cs)[switch]#
Enter the Interface FXO con-
figuration mode
Response: The prompt in the
Interface FXO configuration
mode is (if-fxo) [if-name] #
after detection of dial-tone
(default) or to wait for a
specified timeout (in sec-
onds). Zero (0) seconds will
initiate dialing immediately
after going off-hook.
command.
354