Table of Contents
Advertisement
SmartWare Software Configuration Guide
Procedure: To configure call holding
Mode: Interface FXS
Step
1
node (if-fxs)[ if-name ]#[no] call-hold
Example: Disable call holding
The following example shows how to disable call holding
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxs MyFxsIf
node(if-fxs)[myFxsIf]#no call-hold
Configuring call waiting supplementary service (optional)
The call waiting supplementary service can be administratively enabled or disabled. If disabled, the terminal
is considered busy when in a call. An incoming call is thus not presented to the user, and the caller hears
a busy-tone.
The user of the device connected to the FXS port can be given the possibility to activate/deactivate call waiting
by means of a special digit sequence touched on the keypad of his device (see section
service tables"
on page 329 for more information). The configuration in the FXS interface is administrative,
this means if call waiting is disabled here, the user cannot activate it anymore.
Procedure: To configure call waiting
Mode: Interface FXS
Step
1
node (if-fxs)[ if-name ]#[no] call-waiting
Example: Disable call waiting
The following example shows how to disable call waiting
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface fxs MyFxsIf
node(if-fxs)[myFxsIf]#no call-waiting
Configuring additional call offering supplementary service (optional)
The additional call offering supplementary service can be administratively enabled or disabled. If disabled, the
user doesn't have the possibility to make a callback during an active call.
Procedure: To configure additional call offering
FXS interface configuration task list
Command
Command
29 • FXS interface configuration
Purpose
Enables/Disables call holding supplementary ser-
vice (Default: enabled)
Purpose
Enables/Disables call waiting supplementary ser-
vice (Default: enabled)
"Configuring the precall
346
Advertisement
Table of Contents
Troubleshooting
