Enable The Gateway; Registering With A Registrar (Optional) - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
node(gw-sip)[sip]#bind interface eth0

Enable the Gateway

In order to become active the SIP gateway must be enabled. The following procedure enables the SIP gateway:
Mode: Gateway SIP
Step
1 node (gw- sip )[ sip ]#no shutdown
Example: Enabling an SIP Gateway Configuration
The following example shows how to enable an already defined SIP Gateway.
node(cfg)#gateway sip sip
node(gw-sip)[sip]#no shutdown

Registering with a registrar (optional)

If necessary, the SIP gateway can register one or more users with a SIP compliant registrar. If the gateway is
used as a gateway to the PSTN, this functionality is usually not required. However, if the gateway is responsible
for terminals, which are directly attached to it, it is often required that the gateway registers the phone numbers
or usernames associated with these terminals with a registrar.
Procedure: To register users with a SIP registrar
Mode: Gateway SIP
Step
1 node (gw-sip)[sip]#registrar address [port]
[ use-default-server ]
2 node (gw-sip)[sip]#user name
3
Gateway configuration task list
Command
Command
39 • SIP gateway configuration
Purpose
Enable the SIP gateway
Purpose
Specify the registrar server to be used for reg-
istration.
The address may be either an IP address or a
name to be resolved by DNS.
It is also possible to specify a SIP domain
name to be resolved using DNS SRV records
as the address.
If the registrar uses a different UDP port.than
the default port 5060 for receiving mes-
sages, the port number can also be specified
here.
If the use-default-server parameter is speci-
fied, the REGISTER messages will be sent via
the default server instead of directly to the
registrar.
Adds a user to be registered with the regis-
trar. The name can be either a name as used
in sip URIs or a phone number.
Repeat step 2 to add more than one user to
be registered.
494