Rip Configuration Task List; Enabling Send Rip - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
RIP 2 is more useful in a variety of environments and allows the use of variable subnet masks on your network.
It is also necessary for implementation of classless addressing as accomplished with CIDR (classless inter-
domain routing).
It is recommended that RIP 2 be used on any segment where all routers can use the same IP routing protocol.
If one or more routers on a segment must use RIP 1, then all other routers on that segment should also be set
to use RIP 1.
RIP configuration task list
To configure RIP, perform the tasks described in the following sections. The tasks in the first two sections are
required; the tasks in the remaining sections are optional. Most of the RIP commands have the character of a
flag, which is either enabled or disabled.
•

Enabling send RIP

• Enabling an interface to receive RIP (see
• Specifying the send RIP version (see
• Specifying the receive RIP version (see
• Enabling RIP learning (see
• Enabling an interface to receive RIP (see
• Enabling RIP announcing (see
• Enabling RIP auto summarization (see
• Specifying the default route metric (see
• Enabling RIP split-horizon processing (see
• Enabling the poison reverse algorithm (see
• Enabling holding down aged routes (see
• Displaying RIP Configuration of an IP interface (see
• Displaying global RIP information (see

Enabling send RIP

By default an interface does not send any routing information. This procedure describes how to enable sending
RIP packets on interface
Mode: Interface
Step
node (if-ip)[ name ]#rip supply
1

RIP configuration task list

page
page 199)
page 200)
page 200)
page
page 201)
page
page
page
page
page
page
Command
199)
201)
202)
202)
203)
203)
204)
page 204)
205)
Enables send RIP on interface name
17 • RIP configuration
Purpose
198