Disable Interface Ip Address Auto-Configuration From Ppp; Creating A Ppp Subscriber - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Step
node (if-ip)[name]#use profile napt name Assigns the NAPT profile name to applied to
5
(optional)
Example: Create an IP interface for PPP
The following procedure creates an IP interface that can be used for all three types of link layers. The com-
mand lines
tcp adjust-mss
node(cfg)#context ip router
node(ctx-ip)[router]#interface ppp_interface
node(if-ip)[ppp_int~]#point-to-point
node(if-ip)[ppp_int~]#ipaddress unnumbered
node(if-ip)[ppp_int~]#tcp adjust-mss rx mtu
node(if-ip)[ppp_int~]#tcp adjust-mss tx mtu
Disable interface IP address auto-configuration from PPP
This procedure enables/disables automatic configuration of the interface IP address from the PPP network
control protocol negotiation.
Mode: profile ppp
Step Command
[ name ] (pf-ppp)# [no] local-address-
1
autoconfig

Creating a PPP subscriber

One or more PPP subscriber shall be configured if either PPP peer requires authentication. This procedure
describes how to create a PPP subscriber
Mode: Configure
Step Command
1 node (cfg) # subscriber ppp name
PPP configuration task list
Command
only apply to Ethernet link layers.
24 • PPP configuration
Purpose
this IP interface. See 11,
on page 122 to learn how to create a
ration"
NAPT profile.
Purpose
Enables or disables auto-configuration of the
local IP address from PPP. Default: enabled.
Purpose
Creates the new subscriber name , which con-
tains the authentication settings.
"NAT/NAPT configu-
268