Patton electronics SmartWare R.3.20 Software Configuration Manual page 101

SmartWare Software Configuration Guide
The following procedure guides you through the steps necessary to enable RADIUS accounting in an
existing configuration:
Mode: Configure
Step
1 node (cfg)# radius-client
<client-name>
2 node (radius)[client- name ]#
radius-server <server-
name-or-ip> [<udp-port>]
node (radius)[client- name ]#
3
shared-secret authentica-
tion <secret>
4 node (radius)[client- name ]#
profile aaa <pf-name>
5 node (pf-auth)[pf- name ]#
method radius <radius-
client-name>
node (pf-auth)[pf- name ]#
6
context cs
7 node (ctx-cs)[ctx-name]#
service aaa <name>
8 node (svc-aaa)[svc-name]#
accounting use profile
<aaa-profile-name>
9 node (svc-aaa)[svc-name]#
nas-identifier <nas-identi-
fier>
10 node (svc-aaa)[svc-name]#
(Optional)
authentication use profile
<aaa-profile-name>
11 node (svc-aaa)[svc-name]#
(Optional)
accounting-failure-action
[drop-calls | ignore]
RADIUS configuration
Command
Create a new RADIUS client
Define the RADIUS server to be used. If the UDP port is omit-
ted, the default port 1812 is used.
For accounting RADIUS servers often use
Note
port 1813)
There might also be RADIUS servers, which still
Note
use the old RADIUS ports 1645 or 1646)
Define the shared secret to access the RADIUS server
Create an AAA profile, which uses the RADIUS client
Define your newly created radius client as the AAA method
to be used.
If you require redundancy, you can create multi-
Note
ple radius clients and add all of them to the
AAA profile.
Switch to the circuit-switching context.
Create an AAA call-control service
Define the newly created AAA profile to be used for account-
ing using this AAA service.
Define the NAS-Identifier string to be included in RADIUS
requests sent from this AAA service.
Optionally, you can also configure the AAA service to
request authentication using the calls calling E.164 number.
If this is required, you can define the AAA profile used for
authentication using this command.
Define, if calls shall be dropped, if accounting fails. The
default is to ignore accounting failures.
8 • RADIUS Client Configuration
Purpose
101