Distribution Group Service Examples - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
- 4 call destinations
- No max. concurrent
- 4 call destinations
- max. concurrent = 2
- timeout = 5
Procedure: To create and configure a distribution group service
Mode: Context CS
Step Command
1 node (ctx-cs)[ switch ]#service distribu-
tion-group service-name
2 node (svc-hunt)[ service-name ]#cyclic
3 node (svc-hunt)[ service-name ]#max –
concurrent max-concurrent
4 node (svc-hunt)[service-name]#timeout
timeout
5 node (svc-hunt)[service-name]#route
call dest-interface interface-name
or
node (svc-hunt)[service-name]#route
call dest-table table-name
or
node (svc-hunt)[service-name]#route call
dest-service service-name
6
Note
If you specified the maximum number of concurrent destinations and the
distribution group tried each destination, the final destinations ring until
someone picks up one of the phones.
Call router configuration task list
after 5s
Figure 63. Distribution group service examples
Creates a new distribution group service and enters distribu-
tion group configuration mode.
Configure the distribution group for cyclic operation mode.
Subsequent calls try another first destination in a round-robin
method. Default is not to use cyclic mode – always to start
with the first configured destination(s).
Configures how many destinations shall be called at the
same time. If you also configure a timeout, the first call is
cleared and an additional call is made after that timeout.
Thus only the specified number of destinations is ringing at
the same time.
Configures a timeout in seconds after which one destination
is dropped and a next destination is called.
Adds a route to a destination. This is the interface, table or
service that is tried to call during the distribution group's
attempt to make calls to the destinations. The destination can
either be an interface or you can route the call again to a
routing table or directly to another service. This allows you
cascading services.
Repeat step 5 to add additional hunting destinations.
33 • Call router configuration
4 picks up
after 10s 4 picks up
Purpose
432