Dhcp-Client Configuration Tasks; Enable Dhcp-Client On An Ip Interface; Dhcp-Client And Dhcp-Server - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
DHCP-server and DHCP-client are illustrated in
DHCP Clients
DHCP-client configuration tasks
To configure the SmartNode as DHCP-client perform the steps mentioned below.
•

Enable DHCP-client on an IP interface

• Release or renew a DHCP lease manually (advanced) (see
• Get debug output from DHCP-client (see
• Configure DHCP agent
Enable DHCP-client on an IP interface
On every created IP interface a DHCP-client could be enabled. If enabled, the SmartNode gets the IP address
for this interface from a DHCP-server. Additionally other configuration information is received for this IP

DHCP-client configuration tasks

figure
LAN
LAN
Node
Node
LAN
DHCP Server
Figure 38. DHCP-client and DHCP-server
page 249)
38.
Node
Node
WAN
DHCP Clients
Node
Node
page 249)
21 • DHCP configuration
DHCP Server
247