Deleting Call Services; Activate The Call Router Configuration - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Caveat: For calls from the IP side, the service only works if the G711.alaw codec is chosen. On the SmartNode
4960 the service is available for all configurable codecs.
Mode: Context CS
Step Command
1 node(ctx-cs)[switch]#service second-
dialtone name
2 node(svc-2dt)[name]#route call dest-
interface|dest-service|dest-table
name
node(svc-2dt)[name]#route
3
announcement dest-inter-
face|dest-service|dest-table
name
node(svc-2dt)[name]#use profile
4
tone-set name

Deleting call services

To remove individual call services you can use the
Procedure: To delete a call service
Mode: Context CS
Step Command
node(ctx-cs)[switch]#no service service-
1
name
Example: Remove an entire mapping table
node(cfg)#context cs
node(ctx-cs)[switch]#no service HUNT-BRI
Activate the call router configuration
Prior to activate the call router configuration you can show the whole context CS configuration and the entire
call routing tables.
The call router configuration is activated as soon as the CS context comes out of shutdown (e.g. at boot time or
by manually entering command
active after 3 seconds. SmartWare offers a number of possibilities to monitor and debug the CS context and
call router configurations. For more information refer to chapter 52,
Note It is not necessary to shutdown the CS context prior to making any configu-
ration changes.
Call router configuration task list
Enters the service second-dialtone mode.
Defines the call destination. If the call cannot be placed the
second-dialtone is played.
Instead of playing a dialtone locally, the service sets up a call
to the configured message provider.
Apply to use a alternative tone-set profile. If not configured
the profile tone-set default will be used.
form of the
no
Delete the service service-name.
Note:
just deleting it. The type must only be specified when creating
a service.
). You can modify the configuration at runtime; changes will be
no shutdown
40 • Call router configuration
Purpose
command.
service
Purpose
You do not have to enter the type of the service when
"VoIP debugging" on page 615.
509