Configuring Caller-Id Presentation (Optional); Configuring Flash Hook Processing (Optional) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Interface FXS
Step
1
[name](if-fxs)[name]#[no] subscriber-
number <number>
Configuring an alternate PSTN profile (optional)
The PSTN profile contains the configuration for data/voice transmission on circuit-switched channels (See
chapter 48, "PSTN profile configuration"
to the analog line associated with the interface. There is a PSTN profile named default, which always exists in
the system. If no different PSTN profile name is explicitly configured on the FXS interface, the profile named
default is used.
Mode: Interface FXS
Step
1
[name](if-fxs)[name]#use profile pstn
profile-name
Configuring caller-ID presentation (optional)
FXS/FXO protocols allow the presentation of the caller-ID (calling party number and name of an incoming
call) to an analog terminal when the terminal is ringing. (See Chapter 43,
page 532 for other caller-ID related settings.) Use this command to configure presentation of the calling party
number to the analog device connected to the FXS port associated with the interface.
Mode: Interface FXS
Step
1
[name](if-fxs)[name]#[no] caller-id-pre-
sentation {pre-ring | mid-ring}
Configuring flash hook processing (optional)
The flash-hook command specifies if the flash hook pattern must be handled locally or if it must be relayed to
the remote subscriber. Per default flash hook is handled locally because it is the initial pattern for local initiated
supplementary services. If the flash hook is relayed to the remote subscriber, the local user will not be able to
initiate a second call. The relay feature is used if the termination instance of the remote protocol is configured
to handle all the supplementary services.
Mode: Interface FXS
Step
1
[name](if-fxs)[name]#flash-hook {han-
dle-locally | relay}
FXS interface configuration task list
Command
on page 592). In the case of FXS interfaces, the PSTN profile applies
Command
Command
Command
35 • FXS interface configuration
Purpose
Applies a subscriber number for the fxs interface.
The no form of the command clears an existing one.
Default: none
Purpose
Defines an alternate PSTN profile to be used for this
FXS interface.
"FXS port configuration"
Purpose
Enables/Disables the caller-id presentation and
defines if it must be sent before ring starts or in the
first ring pause.
Purpose
Defines processing instance of the flash hook pat-
tern.
Default: handle-locally
on
404