Dell PowerConnect 8024 Cli Reference Manual page 143

[Boot Menu] 9
Are you SURE you want to reset the system? (y/n):y
Boot code......
SDRAM 256
Boot Menu Version: Oct 20 2004
Select an option. If no selection in 10 seconds then
operational code will
start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
• Option to Boot Without Using Startup Configuration and Only Load System Default.
Selecting 10 from the Boot Menu restores system defaults. The boot sequence is started by
selecting '1' from Boot Menu.
[Boot Menu] 10
Are you SURE you want to delete the startup-config? (y/n):
• Option To Activate the Backup Image. This option determines the active image and toggle
the bootloader to use the backup image.
[Boot Menu] 11
Backup image - image1 activated.
• Option to use the password recovery procedure. It allows the switch to boot one time
without prompting for a console password. Note that the 'enable' password is not prompted
for in this mode.
[Boot Menu] 12
Monitoring Traps from CLI
It is possible to connect to the CLI session and monitor the events or faults that are being sent
as traps from the system. This feature is equivalent to the alarm-monitoring window in a typical
network management system. The user enables events or monitor traps from the CLI by
143
Using the CLI