Dell PowerConnect 8024 Cli Reference Manual page 105

sFlow
Command
sflow destination
sflow polling
sflow polling (Interface Mode)
sflow sampling
sflow sampling (Interface Mode)
show sflow agent
show sflow destination
show sflow polling
show sflow sampling
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
SNMP
Command
show snmp
show snmp engineID
show snmp filters
show snmp groups
show snmp users
show snmp views
show trapflags
snmp-server community
snmp-server community-group
snmp-server contact
snmp-server enable traps
Description
Configures sFlow collector parameters (owner string,
receiver timeout, ip address, and port).
Enables a new sflow poller instance for the data source if
rcvr_idx is valid.
Enable a new sflow poller instance for this data source if
rcvr_idx is valid.
Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
Displays the sflow agent information.
Displays all the configuration information related to the
sFlow receivers.
Displays the sFlow polling instances created on the switch. PE
Displays the sFlow sampling instances created on the
switch.
Description
Displays the SNMP status.
Displays the SNMP engine ID.
Displays the configuration of filters.
Displays the configuration of groups.
Displays the configuration of users.
Displays the configuration of views.
Shows the status of the configurable SNMP traps.
Sets up the community access string to permit access to
SNMP protocol.
Maps SNMP v1 and v2 security models to the group name. GC
s up a system contact (sysContact) string.
Set
Enables SNMP traps globally or enables specific SNMP
traps.
Mode*
GC
GC
IC
GC
IC
PE
PE
PE
Mode*
PE
PE
PE
PE
PE
PE
PE
GC
GC
GC
105
Command Groups