3Com 3C10402B Administrator's Manual page 94

94 C 5: T
HAPTER ELEPHONE
C
ONFIGURATION
and a default set of properties. The telephone's display panel displays
the extension.
Manual method — You can use the NBX NetSet utility to disable
■
Auto Discovery and configure telephones manually. However, if you
have many telephones to configure, manual configuration can be a
tedious and error-prone process.
For either method, you need to connect the telephone to the network. If
you use Auto Discovery, enable the Auto Discover Telephones check box
before you connect the telephone. If you add a telephone manually, you
can connect the telephone before or after you use the NBX NetSet utility
to add it.
Connecting the Telephone
Instructions for connecting the telephone to power and the network
depend on your power source and the type of telephone. See Chapter 3
in the NBX Installation Guide or the telephone packing sheet for
telephone connection information.
Adding a New Telephone Using Auto Discovery
Before you enable Auto Discovery, verify that a 3-digit or 4-digit dial plan
is installed on the Call Processor and that you have specified a starting
extension. See the NBX Installation Guide for more information.
To add a new telephone using Auto Discovery:
1 Click System-Wide Settings > Auto Discovery.
2 Optionally, clear all check boxes associated with autodiscovering devices.
3 Enable Auto Discover Telephones, and then click Apply.
4 Optionally, enable the Auto Add Phones to Call Pickup Group 0 check
box.
Regardless of whether you select this check box, you can change the call
pickup group for any telephone later. See
more information.
5 Click OK.
"Call Pickup" on page 51 for