Adding Telephone Users And Devices; Adding A Generic Sip Telephone - 3Com 3C10402B Administrator's Manual

/
/
Table Entry Create
Adding Telephone
Users and Devices
Adding a Generic SIP
Telephone
The only change required is in the dial plan prefix entry table because in a
Public conference, you need to define a range of extensions rather than a
single extension.
For example, using the above configuration and taking the case that the
extensions range from 700-799, the table entry can be as follows:
ID Entry Digits
--- ----- ------
1 7 7
If the caller dials 700, the system receives the extension of 3Com IP
Conferencing Module and the port number for the Public conference
from the dial plan. The system can route the call to the 3Com IP
Conferencing Module.
This section explains how to add a generic SIP telephone or a 3Com 3108
Wireless Telephone to a SIP-mode system. For information about how to
add other types of 3Com telephones, see
page 93, which describes how to add devices manually or by using the
Auto Discovery feature. The procedures apply to both SIP mode and
3Com call control mode systems. However, because the 3Com 3108
Wireless Telephone is a SIP device, you cannot use Auto Discovery to add
it to the system. See"Adding a 3Com 3108 Wireless Telephone"
page 255 for information about how to add a 3108 to a SIP mode
system.
To add a generic SIP telephone to the SIP mode system,
Add a new telephone user and extension to the system and then
■
configure the telephone with that username, the default password
(1234) and the extension. If you are not using a DHCP server, you
might need to configure IP connection information.
Configure the SIP telephone with system data, such as the system IP
■
address and UDP port authentication information, and the extension
you created in the NBX NetSet utility.
The SIP telephone has configuration interface that lets you configure
it. Most generic SIP telephones include an embedded web server that
enables you to connect to the phone directly and configure
authentication and feature settings. After you configure the SIP

Adding Telephone Users and Devices

Min Max Class
--- --- -----
3 3 internal
"Telephone
253
Prio Route
---- -----
0 900
Configuration"on
on