3Com 3C10402B Administrator's Manual page 441

Table 83 Configuration and Status Report Headings (continued)
Heading Description
los TEP performance data. Loss Of Signal Seconds, G.826 Near
End. Number of seconds during which the signaling channel
was lost.
lossl TEP performance data. Loss of Signal Seconds, T1.231 Near
End. Number of seconds during which no pulses (loss of signal)
have arrived within 100 to 250 bit times.
Local Loopback The state of the setting for the Local Loopback test, either
enabled or disabled.
MAC Address A 48-bit address unique to each network device.
Model Number The model number of the board.
Values:
0x0700 — T1 board 3C10116B
0x0b00 — T1 board 3C10116C
0x0e00 — T1 board 3C10116D
0x0c00 — E1 board 3C10165C
0x0f00 — E1 board 3C10165D
0x0a00 — BRI board 3C10164C
National Prefix An advanced configuration setting. An identifier, up to
five-digits, that can be manually configured for outgoing calls
on this span. Manual configuration of the national prefix is for
situations where the telephone company equipment requires
special configuration on the system.
NCP Conne The amount of time that the Digital Line Card waits for the Call
Processor to connect the call.
"USER_ALERTING_NO_ANSWER" errors mean that this value
might be too small.
NCP Gener A time-out value that controls how long the Digital Line Card
waits for a response from the Call Processor. Do not modify this
value.
Network Digit A time-out value that controls how long the Digital Line Card
waits between digits sent on an incoming call.
OffHk Min The minimum time an analog telephone, connected to an
Analog Terminal Card, must be off hook for the system to
recognize that the telephone has been picked up.
On Line One possible status of a channel.
oof TEP performance data. Out of Frame Seconds, G.826 Near
End. Number of seconds during which there were excessive
frame bit errors.
Payload Loopback The state of the setting for the Payload Loopback test, either
enabled or disabled.
System-level Troubleshooting 441