3Com 3C10402B Administrator's Manual page 306

306 C 11: D
HAPTER IAL
P
LAN
Command syntax is case insensitive. In the sample dial plans supplied
with the system, and in this section, commands use upper and lower case
to make them easier to read.
An entry that begins with "n" for example, nDialPlanID, indicates an
integer field. Integer IDs are used in many places, and must be within
the range 1 through 32768. The system reserves dial plan table ID
numbers 1, 2, and 3 for Internal, Incoming, and Least Cost Routing,
respectively.
An entry that begins with "sz" (for example, szDescription) indicates a
field composed of alphanumeric characters. Acceptable characters are
a through z, A through Z, and 0 through 9.
Each line in the configuration file must contain a complete command.
The system reads all lines in the configuration file, and ignores only those
lines containing one or more syntax errors. The system treats any line that
begins with / (forward slash) as a comment and ignores it.
CAUTION: Do not place comments at the end of a command line.
Table 60 Dial Plan Command Summary
Command Name
Table Create
TableEntry Create
DestinationRoute Create
DestinationRouteEntry Create
DestinationRouteOperation Create
TimedRoute Create
TimedRouteEntry Create
TimedRouteOperation Create
Description
Creates a dial plan table.
Creates an entry in a dial plan table.
Creates a route that specifies the primary and
alternative destination device of a call.
Creates a destination route entry that
identifies a single destination device or device
list.
Creates a digit manipulation operation for a
destination route entry.
Creates a timed route (a route that the system
uses based on defined criteria for time of day
and day of week).
Creates a timed route entry specifying either a
time of day or system mode, day of the week
criteria, and the destination route to use if
that criteria are met.
Creates a digit manipulation operation for a
timed route entry.