Control Parameters; Operations Management - 3Com 3C10402B Administrator's Manual

224 C 9: NBX M
HAPTER

Control Parameters

Operations
Management
ESSAGING
For information about how to configure the dial plan to use VPIM, see
"Dial Plan Configurations and VPIM"
To configure VPIM control parameters, click NBX Messaging > VPIM.
Table 45 explains the VPIM control parameter fields and their purpose.
Table 45 VPIM Tab Fields
Field
Maximum message size (Kbs)
Time between send attempts
(Minutes)
Maximum number of send
attempts
Maximum time before message
expires (Minutes)
To manage the queue of outgoing voice mail messages, click NBX
Messaging > VPIM and then click the Operations Management tab.
Table 46 describes the fields in this window.
Some commands require that you start or stop operations. For example,
to remove a message from the queue, first stop operations. Similarly,
on page 302.
Purpose
Controls the size of incoming messages from other
sites. If a message is larger than the specified
value, the system rejects it. The default value
represents a voice mail message approximately 4
to 5 minutes in length.
Default: 3000 KB
Minimum: 500 KB
Maximum: 5000 KB
For outgoing messages, the system might not be
able to contact the target system on the first
attempt. If so, the system attempts to contact the
target system later. To change the time between
attempts to send a voice mail message, change
this number.
Default: 15 minutes
Minimum: 1 minute
Maximum: 60 minutes
Specifies the number of times the system attempts
to connect to the target system.
After the specified number of send attempts, the
system returns the voice mail message to the
sender's voice mail box with an indication that the
message could not be sent.
Default: 4 attempts
Minimum: 1 attempt
Maximum: 10 attempts
Default: 60 minutes