3Com 3C10402B Administrator's Manual page 308

308 C 11: D
HAPTER IAL
DestinationRoute Create
DestinationRouteEntry
Create
P
LAN
TimedRouteOperation Create
■
Syntax
DestinationRoute Create nRouteId szDescription
Description Creates a route that specifies the primary and alternative
destination device of a call (for example, which CO Line or Digital Line
Card port over which to route the call). If the destination route already
exists, this command removes all of its entries and operations, and
overwrites its description with the new information.
Arguments
— An integer in the range 1 – 32768, uniquely identifying this
nRouteId
destination route.
szDescription — The description or name of the destination route.
Example: This example creates destination route 3 and names it "Voice
Application":
DestinationRoute Create 3 Voice Application
Syntax
DestinationRouteEntry Create nRouteId nEntryId szExtension
Description creates a destination route entry that identifies a single
destination device or device list.
If the specified destination route entry already exists, this command
overwrites it with the new information. During routing, the system
checks the list of destinations in ascending
Arguments
— An integer in the range 1 through 32768.
nRouteId
— An integer in the range 1 through 32768. The system checks
nEntryId
the list of destinations in ascending nEntryId order, and uses the first
available one.
— The extension of the destination device or device list. Note
szExtension
that the system does not dial this extension (that is, it neither checks the
extension against a dial plan nor subjects it to Class of Service restrictions,
digit manipulation, or routing) but instead uses the extension only to look
up the device in the internal device directory.
order (
nEntryId nEntryId
1 first).