3Com 3C10402B Administrator's Manual page 159

Table 35 Auto Extension Configuration
Button Mapping Setting
for This Line
Not mapped to any
telephone
Not mapped to any
telephone
Mapped to a button on the
Receptionist's Telephone (or
to a button on an Attendant
Console associated with the
Receptionist's telephone)
To configure a line card port manually:
1 Click
PSTN Gateway Configuration
2 Click Add.
3 Specify the port information. See the online Help for more information.
4 Click OK.
5 Connect your CO line to the configured port.
Auto Extension Behavior
The extensions you specify in the Auto Extension fields control where the
system directs a call.
Extension.
Auto Extension
Setting Incoming Call Behavior
Extension of the Receptionist's telephone rings. If no one answers, the call transfers
Receptionist to the call coverage point defined for the Receptionist's telephone.
The transfer occurs after the number of rings specified for the
Receptionist's telephone.
500 Calls go directly to the Automated Attendant without ringing any
telephone.
Extension of the Receptionist's telephone rings. If no one answers, the call transfers
Receptionist to the call coverage point defined for the Receptionist's telephone.
The transfer occurs after these two values are surpassed:
■
■
Example: If the Time Out value for the Analog Line Card port is 12
seconds, the equivalent number of rings is 2. If the Call Forward
settings for the receptionist's telephone is 4 rings, then the call
transfers after 6 rings.
Configuring and Managing Analog Line Card Ports
> Analog Line Cards.
Table 35 describes typical the behaviors for Auto
The number of seconds specified in the Time Out field for the
appropriate time of day (Open, Closed, Lunch, Other). Click
PSTN Gateway Configuration > Analog Line Cards and click an
extension.
The number of rings specified in the user settings for the
Receptionist's telephone.
159