Removing A Digital Line Card; Setting Up A Digital Line Card At A Remote Location - 3Com 3C10402B Administrator's Manual

Removing a Digital
Line Card
Setting Up a Digital
Line Card at a
Remote Location
4 Click Assign Addresses Individually.
3C10165D E1, 3C10116D T1, and 3C10164D BRI Digital Line Cards need
only one IP address, therefore the Assign Addresses Individually button is
not present for these cards.
5 Enter the appropriate IP addresses for the channels.
6 Enter IP values in the Common Subnet Mask and Common Default
Gateway fields.
7 Click OK.
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card might affect your dial plan.
To remove a Digital Line Card:
1 Click PSTN Gateway Configuration > Digital Line Cards.
The T1/ISDN Board List shows the installed T1, ISDN PRI, and ISDN BRI
cards.
2 Select the card, or cards, that you want to delete and click Remove
Selected. To select all extensions, enable the Select check box.
3 Click OK when the system prompts you to confirm.
Each 3C10116D T1, 3C10165D E1, or 3C10164D BRI Digital Line Card
can function as a standalone unit and communicate with the Call
Processor over a routed network.
To function as a remote card, the card must have the normal IP settings
(IP address, default gateway, and subnet mask), plus the IP address of the
Call Processor.
The 3C10116D, 3C10165D, and 3C10164D Digital Line Cards can use
static IP configuration or they can get their IP configuration from a DHCP
server. Auto Discovery downloads the Call Processor IP address to the
card. The card stores that information in its non-volatile memory.
3C10165D E1 and 3C10116D T1 Digital Line Cards do not support DHCP
lease times of less than 20 minutes.

Setting Up a Digital Line Card at a Remote Location

183