Quality Of Service Control - 3Com 3C10402B Administrator's Manual

Networked telephony systems
Hide thumbs Also See for 3C10402B:
Table of Contents

Advertisement

478
A
D: C
X
H.323 G
PPENDIX
ONNE
TIONS
ATEWAY
causes are faulty wiring, connectors, and termination. High-bandwidth
LANs (100BASE-T) are more likely to have termination problems than
10BASE-T LANs.
Packet Delay
Latency and jitter delays affect the Quality of Service.
Latency
Latency is the sum of all the fixed delays in an end-to-end connection.
Latency prevents a caller from responding immediately to another caller's
remarks.
Most people notice latency when the end-to-end delay is above 200 ms.
(The round-trip delay is typically no greater than 400 ms.) Conversations
sound most natural when latency is below this range. Network latency
can be measured by "pinging" the network connection, but the network
connection is only part of the delay. The entire end-to-end delay also
includes the H.323 gateway, firewall or router, and the LAN itself. System
administrators can control some local device delays by controlling the
system load and by upgrading system components as needed.
Jitter
Momentary transmission delays can affect the pace of a conversation
and, if severe, cause the voice to "break up." This is known as "jitter."
All voice-over-internet devices have a "jitter buffer" at the receiving end
whose purpose is to absorb jitter. It does this by delaying the first packets
that arrive by some significant amount (from 50 to 200 ms). This delay
creates a window of time for receiving the next group of related samples
which are then forwarded to a callee at a regular rate. However, if some
packets are too late, and exceed the jitter buffer capacity, those packets
are lost and there are gaps in the audio.
Quality of
NBX systems address Quality of Service (QoS) issues using methods that
Service Control
are discussed in this section.
Adaptive Jitter Buffering
All IP network devices use buffers to retime the packets that they receive
from a network. Retiming allows these devices to compensate for the
variable delays that occur as the packets pass through an IP network.
H.323 calls take different paths through a network so the ConneXtions

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

V3000 analogV3000 briV3001rV5000Nbx 100

Table of Contents